Belt conveyors can be divided into light belt conveyors and mining belt conveyors. Different types of belt conveyors can be selected according to the customer's location. It can be roughly divided into: large inclined belt conveyor, fixed belt conveyor, mobile belt conveyor. However, whether it is a light belt conveyor or a mining belt conveyor, deceleration, opening, deviation and abnormal noise of the reducer are common problems of the belt conveyor.
Causes of belt conveyor slippage: There is a lot of water spray on the belt conveyor, overload and insufficient belt tension. When the vehicle is fully loaded, the belt will be squeezed by the material and enter between the driving roller and the belt. The design value of the friction coefficient does not match the actual value. Control method: Take anti-watering measures, control the paper feed volume, prohibit overload operation, adjust the tension roller, and increase the belt tension.
When pressing down the belt, first remove some materials from the belt, and then drive to increase the friction coefficient of the driving roller. Secondly, the material of the belt conveyor 1, the transportation point is mainly located in the falling hopper, guide groove, etc. Overload, the rubber skirt of the belt conveyor baffle is damaged, and the steel plate at the guide groove is designed to be away from the belt.
And rubber skirts often disengage materials from the guides. This case, for example, the slot, enhances the maintenance of transportation capacity control, and when the concave belt is suspended, in the concave belt portion, when the curvature radius of the concave portion is small, the belt is suspended. At this time, the belt is slotted, and the belt leaves the slotted idler group, so the angle of the belt slot becomes smaller, and some materials splash out.